General Electric Valve

Fix a refrigerator not dispensing water or making ice with this water inlet valve replacement. Common repair for no water flow to dispenser or icemaker.

This vent flapper is the exterior exhaust flap that opens to let dryer air and lint exit and closes to keep weather, pests and drafts out when the dryer is off. It restores proper airflow at the outside vent hood. What it does:

• Opens with dryer airflow to allow exhaust to escape and closes when idle to block outside air.
• Helps prevent backdrafts, pests and rain from entering the vent system.
• Can restore normal drying performance when a stuck or broken flap was restricting airflow.
• Commonly replaced when the flap is cracked, warped, jammed or does not seal.

• One vent flapper/exterior exhaust flap.

• Disconnect power to the dryer (and gas supply if applicable) and work from the outside hood when possible.
• Remove the exterior vent hood or access cover to inspect and replace the flap; basic hand tools required.
• Check that the flap moves freely after installation and seats against its seal to prevent air leaks.
• Clean or repair the ductwork to avoid repeat failures.

No water or ice? This inlet valve assembly controls water flow to your refrigerator's dispenser and ice maker, restoring fill function in under an hour.

Range won't heat or gas won't flow? The safety valve controls gas flow to burners. This common failure part restores proper oven operation safely.

Burner won't light or flame is too low? This range top burner valve controls gas flow to surface burners. Moderate DIY repair with basic tools.

Oven won't heat or gas smell? This safety valve controls gas flow to bake and broil burners. Restores safe, reliable oven heating operation.

Fix a burner that won't light, won't adjust, or has uneven flames with this gas cooktop valve. Controls gas flow to individual burners for safe operation.

Oven won't heat or igniter glows but burner won't light? This range oven safety valve controls gas flow to the burner. Moderate DIY repair.

Fix washer not filling or slow water flow with a new water inlet valve. Controls water entry to your washer. Moderate DIY repair, 30-45 minutes.

Fix no water to dispenser or ice maker issues with this refrigerator water inlet valve. Controls water flow to restore normal dispensing function.

Fix a refrigerator that won't dispense water or make ice with this water inlet valve solenoid assembly. Direct replacement part for select models.

Replace your range top burner valve if burners won't light, flame is weak or uneven, or gas won't flow. Common repair for gas ranges with ignition issues.

Fix a washer that won't fill with water or has slow fill issues with this water inlet valve. Controls water flow into your machine. DIY-friendly repair.

This gas valve controls gas flow to the burners and oven, restoring reliable ignition and consistent heat when the burner won't light or the oven won't heat properly. Designed as a direct replacement part. What it does:

• Regulates gas supply to the oven and cooktop burners for proper ignition and consistent flame
• Commonly replaces valves that cause burners not to light or the oven to not maintain heat
• Helps stop irregular gas flow that can lead to weak or fluctuating flames
• Works with the appliance's safety and control systems to open and close gas flow as commanded

• One gas valve as shown

• Shut off the gas supply and disconnect power before starting any repair
• Only install on compatible appliances;
• Tighten gas fittings to the manufacturer's torque spec and test with a leak solution

Fix a gas range that won't heat with this safety valve assembly. Controls gas flow to oven and burners, restoring safe operation when the valve opens.