Hinge Parts

Supports and pivots refrigerator or freezer doors. Replace this hinge assembly if your door is sagging, has worn pivot points, or was lost during a move.

This replacement hinge supports and pivots the appliance door so it opens and closes smoothly and stays aligned. A worn or bent hinge can lead to door sagging, scraping, or poor latching that impacts performance and safety. What it does

• Supports the door and provides the pivot point for opening/closing
• Maintains door alignment to help ensure a proper seal
• Restores smooth, consistent door motion
• Common symptoms: door sags, squeaks, scrapes, or won't latch/stay closed

• 1 hinge

• Disconnect power before servicing; for gas units, also shut off gas supply
• Support the door while removing/installing fasteners to prevent stress on the panel
• Reuse original mounting screws/hardware unless damaged
• After installation, adjust if needed

Lower hinge pin serves as the pivot shaft for your refrigerator door. Replace this part if worn, bent, broken, or missing to restore smooth door movement.

Supports and pivots the hinged dryer top panel for service access. Replace if cracked, broken, or causing wobble, scraping, or alignment gaps.

Door hinge pin assembly for dryers. Provides the pivot point for your dryer door, supporting its weight during opening and closing. Replace if bent or worn.

Snap bushing installs in door panel openings to protect wiring or tubing. Replace if cracked, missing, or worn to prevent chafing and pinching.

Precision bearing for refrigerator door hinge pins. Supports smooth door swing and reduces friction. Replace if worn, cracked, or causing stiff movement.

Replacement bottom hinge pin for refrigerator doors. Restores proper door pivot and alignment when original pin is worn, bent, or missing during moves.

The shut-off arm is the lever that tells the ice maker when to stop and start making ice. Replace a bent, missing, or jammed arm to restore proper ice production control and prevent bin overfilling. What it does:

• Lowers to allow ice production; raises to stop cycles when the bin is full (down = on, up = off)
• Helps prevent overfilling, spills, and auger jams
• Common symptoms: ice maker won't stop making ice, no ice when the arm is stuck up, inconsistent ice production from misalignment
• Restores proper ice level sensing when the original lever is damaged or missing

• One shut-off arm

• Disconnect power and shut off water before servicing
• Remove the ice bin to access the ice maker
• Seat the arm's pivot ends fully in the ice maker head; avoid bending the lever
• The arm moves freely up/down and clears the bin before restoring power

Gray door hinge for side-by-side refrigerators. Replaces cracked, broken, or worn hinges that cause misalignment or sagging doors.

Door hinge butt for top-mount refrigerators. Mounts between cabinet and door to support hinge pin assembly. Replace if cracked, broken, or worn out.

Replacement oven door hinge for ranges. Restores smooth door operation when the original is worn, broken, or damaged. Installs on left or right side.

Securely attaches the oven door to the range cabinet. Replace if your hinge is cracked, bent, worn, or causing the door to hang unevenly or not close properly.

Replaces a bent, worn, or damaged refrigerator door hinge. Restores smooth pivot action and proper door alignment for even gasket seal contact.

Replace worn, damaged, or broken range door hinges. Installs on both ends of the oven door to enable smooth opening and closing. Essential when hinges fail.

Cushioning pad that installs between the washer lid hinge and cabinet. Replace if cracked, worn, or missing to reduce squeaks and prevent metal wear.