Valve

Ordered and installed new valve per description on your web site. I found the part by the supplied diagram on your web site. I ordered it on Wednesday and had it delivered by FedEx the next day. Read more

I replaced the igniter, thermal fuse, oven sensor, & gas safety valve. Read more

• No hot or cold water
• Will not fill with water
• Will not stop filling with water

I ordered the replacement inlet valve from your site, installed it in 20 minutes. the washing machine now fills to extra large capacity in 3 minutes. The machine is an old Kenmore bought new in 1985, this inlet valve is the only component to fail in the over 30 years we have had it. Read more

I replaced both items. And it was easier than I thought. Read more

1. Replaced the Dishwasher motor and pump assembly. 2. Replaced the lower arm sprayer. 3. Replaced the Sump and filter. Replaced both the inlet and outlet hoses. 4. Replaced the Airgap. 5. Replaced Float Dome. 6. Replaced Water Inlet Valve. Parts $220 for Dishwasher Estimated Labor $400.00 Labor $0.00 Parts $100.00 for Pullout Faucet Estimated Labor $175.00 Labor $0.00 Read more

• Not dispensing water

Replaced primary inlet water valve and secondary water valve. Read more

• Will not fill with water

Changed inlet valve super easy on my whirlpool dishwasher took the front kick panel off turned off water and electricity the valve was right out front bottom left one small sheet metal screw held it on disconnected plug and 5/8 water line and hose with clamp for fill to tub just reverse for install of new valve Read more

• overflowing
• Will not fill with water

The indications made me think the dishwasher was not shooting water. I checked the water valve with a voltmeter and it was getting power to open. I disconnected the line to make sure the water line was not plugged. Then I bypassed the door switch and ran the dishwasher with the door open and did not see the water filling which pointed to the inlet valve. I ordered the valve which came quickly. Replaced the valve and now the dishes are clean! Read more

Just needed a part that I lost during disassembly. Of course I found it after I got the replacement....?? Read more

• Leaking
• Ice maker dispenses too much ice
• Not dispensing water
• Ice maker not making ice

After reviewing a few blogs it was clear that Frigidaire is knows there is a problem. One of the blogs recommended AppliancePartsPros.com for a new pressure sensor switch and a water inlet valve. Ordered the part and it was shipped that day, as promised. Pulled the dishwasher out (which was the hardest part of the repair). The pressure sensor switch is a changed out with a small flat blade screw driver to release two snap clips. The inlet valve is changed out with three screws and on hose... Read more