Washer Dryer Combo Parts

Replaced transmission and support assembly. Hub nut corrode on support, spanner wrench would not loosen. Had to use 1 11/16 deep socket and impact wrench to remove, basket would not com off support even after cleaning out and soaking with penetrant and using automotive air hammer to push out. I had to cut support plate in half with die grinder, cut bearing from shaft and punch out agitator shaft then use die grinder with carbide burr to cut basket shaft in two before basket would come off... Read more

Replaced clutch assembly, gearcase input shaft seal and motor coupler. When I disassembled the washer I realized the shaft seal on the top of the gearcase was leaking and not the input shaft seal. So had to order more parts before I could finish this job. Altogether I replaced agitator dogs, both seals on the gearcase, the clutch assembly and the motor coupler. Agitator dogs replacement is a very easy job, no tools required, takes less that 5 minutes and made a huge difference with how well... Read more

And after replacing the thermal fuse The dryer turned on. Read more

Replaced all three dampers and then replaced locking gaskets for the top spring mounts for the drum, replaced the old feet pads I had and works like a charm! Read more

One day my wife went to bake something and the bake/broil buttons as well as #3, #9, and oven light ceased to work. Local repair guy came by and wanted to charge $500 to fix it....YEAH RIGHT! Did a little homework and found this website, spoke with knowledgable staff who pointed me in the right direction. Took me all of about 20 minutes to install new control panel..everything works perfect...THANKS! p.s. In doing my research come to find Maytag did little to insulate control panel from oven... Read more

I watched the helpful diy video. It gave me what the problem was and the confidence to do it. Took my dryer apart with the helpful hints in the video repair went smooth. Works like a dream and I saved money. Thank you appliance parts pros. Read more

Replaced it with the new one. Easy as pie!!! Read more

• Won't start
• No heat or not enough heat

Did some dryer repair research (dryer not heating) on the internet. Bought an ohm meter, opened up the dryer and tested the cut-off-T, high limit thermostat, dryer igniter, flame sensor, cycling thermostat for continuity. The igniter was bad, the other parts tested ok. Went online to AppliancePartsPros.com searched for a new igniter for my specific dryer model, found the right replacement igniter and watched the video on how to replace the igniter. Because my dryer is old (15+ years) and I... Read more

Ordered Siphon Break Kit. Speedy shipping, thank you. Attached video shows how to remove front of washer to access screws to loosen top of washer to access siphon break from inside washer cabinet. http://www.do-it-yourself-washing-machine-and-dryer-repair-help.com/siphon-break-Maytagwasher.html Read more

• No heat or not enough heat

I ordered the parts through AppliancePartsPros.com. They were delivered the next day. I installed them and the dryer works great. Read more

Out with the old. In with the new. No problem. Dryers are simple and usually can be fixed quickly. appliance pros makes it easier with their tutorial videos and fast shipping! Read more

I took it apart and cleaned and lubricated the rear support rollers and the belt pulley roller. I think the squealing was coming from the pulley roller. I then replaced the rear felt as it was badly deteriorated. The dryer now runs much more smoothly and quietly. Read more

Installed the new Lid Actuator and the dryers Start Switch. Read more

I went online, ordered the part and installed it,,, took 15 minutes to install,,,saved huge $$$ easy peasy!! :-) Read more