General Electric Clip Or Clamp

Secures refrigerator water lines and tubing in place. Replace if clip breaks, loosens, or causes rattling noises. Confirm fit with your model number.

A small retaining clip that secures the refrigerator drain tube to the cabinet or drain assembly to keep the tube in place and help direct defrost water to the drain pan. Simple replacement for loose or broken clips. What it does:

• Holds the drain tube or drain hose in the correct position to prevent kinks or dislodging
• Helps maintain proper water flow from the defrost/drain channel to the drain pan
• Commonly used when water pools inside the fridge, leaks onto the floor, or drips from the cabinet
• Prevents tube movement that can lead to freeze-ups or overflow at the drain inlet

• One drain tube retaining clip

• Disconnect power to the appliance before beginning any service
• Access the clip by removing the rear or interior access panel as required by your model
• Snap the clip over the drain tube and into the cabinet or mounting boss until it seats securely
• Inspect the tube and surrounding area for blockages or damage while replacing the clip

This mounting clip secures small components or trim in place to prevent movement and noise, restoring proper alignment and fit. It's a simple replacement that helps keep assemblies stable and prevents rattling. What it does:

• Holds trim, panels, or small appliance components in position to maintain proper fit
• Prevents loose parts from vibrating or rattling during operation
• Restores correct alignment for affected trim or assemblies
• Helps maintain a secure connection where clips fasten parts together

• One mounting clip

• Disconnect power to the appliance before attempting any repair
• Verify clip orientation and mating surface before snapping into place
• Replace only the damaged clips to avoid over-tensioning adjacent parts

This water line holder secures a refrigerator or ice maker supply tube to the cabinet or internal frame to keep the line routed and stable. Replacing a worn or missing holder helps prevent rubbing, kinks, and stress on the water line. What it does:

• Holds the water supply line in place to reduce movement and wear
• Helps prevent kinks that can restrict water flow to icemakers and dispensers
• Reduces vibration and potential chafing against sharp edges
• Addresses symptoms like a loose or sagging water line, intermittent flow, or audible line movement

• One water line holder clip

• Disconnect power and shut off the water supply before servicing
• Inspect the water line for damage; replace the line if cracked or leaking
• Mounting may require a screw, push-fit, or slot engagement depending on model—retain existing fasteners or your model's instructions

A replacement clip bar used to secure small components and trim inside compatible appliances. Restores proper retention so panels, wiring, or trim stay in place and reduces rattling or loose parts. What it does

• Secures panels, trim pieces or small assemblies in place to prevent shifting during use
• Holds wiring or harnesses away from moving parts to reduce wear and noise
• Stops rattling or vibration caused by loose clips or retainers
• Helps maintain proper alignment of removable interior components

• One clip bar

• Disconnect power to the appliance before servicing to avoid shock or injury
• Remove adjacent trim or panels as needed to access the mounting location; keep screws and fasteners for reassembly
• Install the clip by lining it up with the mounting slot or tab and pressing or fastening per OEM orientation

Small replacement clip that secures the appliance nameplate or trim piece to the cabinet so the nameplate stays aligned and flush. Restores a finished appearance and prevents the badge from falling loose. What it does:

• Secures the refrigerator/freezer nameplate or trim to the cabinet or door
• Keeps the nameplate aligned and flush with the surface
• Replaces broken, bent or missing clips that allow the nameplate to droop or come off
• Helps eliminate rattling or vibration at the nameplate area

• Disconnect power or unplug the appliance before starting work
• Typically installs by snapping into a designated slot; a small flat screwdriver or trim tool may help with removal and installation
• Inspect surrounding trim for damage and replace additional fasteners if needed