General Electric Clip Or Clamp

This sump clamping nut secures the washer/dishwasher sump seal and housing, helping keep the sump assembly sealed and stable during operation. It's a small but essential fastener for preventing leaks and maintaining proper drainage. What it does:

• Holds the sump/tub seal and sump housing tightly in place to maintain a watertight connection
• Prevents the sump assembly from loosening during spin or wash cycles
• Helps reduce leaks and related water damage when installed correctly
• Works with the factory sump and seal components as the retaining nut

• Replace only with the matching part number; verify orientation before tightening
• Hand-start threads to avoid cross-threading, then tighten to factory spec (do not overtighten)
• Disconnect power and water to the appliance before servicing

This side mount clip kit secures a fridge component to the cabinet frame so panels, trim or assemblies stay firmly in place. It replaces worn or broken mounting hardware to restore proper fit and reduce rattling or sagging. What it does:

• Secures side-mounted panels, trim or brackets to the appliance frame
• Prevents parts from shifting, rattling or coming loose during use
• Restores proper alignment and fit where clips or fasteners have failed
• Simple mechanical part—no electrical connections

• One side mount clip and the matching mounting screws

• Disconnect power to the appliance before starting any repair
• Use correct-size screwdriver; avoid over-tightening screws which can strip threads or crack plastic
• Inspect surrounding clips and mounting points and replace additional damaged hardware as needed

This front panel hanger secures the appliance's front service panel to the cabinet, restoring proper alignment and preventing vibration or sag. It's a direct-fit replacement designed to bring panels back to factory position for a clean, stable appearance. What it does:

• Supports and anchors the front service panel to the appliance cabinet
• Keeps the panel aligned to prevent gaps, sagging, or rubbing
• Reduces rattles and vibration caused by a loose or damaged hanger
• Helps the panel latch securely for safe, normal operation

• One front panel hanger

• Disconnect power before beginning any service
• Partial panel removal is typically required; support the panel during replacement
• Inspect surrounding clips and fasteners; replace if worn to ensure a secure fit

This dryer hose clip secures the exhaust hose to the dryer's cabinet for a stable, sealed connection. A small but essential fastener, it helps keep the vent attached so airflow is directed out of the appliance. What it does

• Fastens the exhaust/vent hose to the dryer cabinet to maintain a secure connection.
• Helps reduce air leaks at the hose-to-cabinet joint that can cause reduced venting efficiency.
• Prevents the hose from slipping off during operation, which can cause vibration or rattling.
• Keeps the vent path aligned to reduce lint buildup at the connection point.

• One dryer hose clip.

• Disconnect power (unplug electric or shut off gas and unplug) before servicing the dryer.
• Remove the dryer vent hose and position the clip over the hose and cabinet fitting; secure per OEM orientation.
• Tighten only to snug — avoid over-tightening which can deform the hose or cabinet inlet.
• Inspect the hose and cabinet inlet for damage; replace damaged components to ensure a proper seal.