Joshua for Model Number 417.39012891 I am trying to locate a legible wiring diagram for my washer. The original has been removed and every online one I can locate is so grainy that I can't read it. I am trying to figure out how to test the motor and control board to figure out which is bad.
Answer Joshua, the motor would have to be tested directly at the harness connector and would be tested as follows: Pin 1 to pin 2 measures at 135 ohms, pin 3 to pin 4 measures 1.26 ohms, pin 9 to pin 4 measures .37 ohms, pin 5 to pin 6 measures less than 5 ohms, and pin 7 to pin 8 measures less than 1 ohm. If the motor tests good, then the voltage output can be tested from the control. Read More... Answered by AppliancePartsPros.com | Thursday, October 24, 2019