John T. for Model Number 41739012890 I can't slide the new motor on the four studs below the washer tub where it is supposed ot fit. If one stud goes in the others are just a milimeter off. I am afraid to force it - the tub studs are plastic and fit into steel thimbles. Any tips on how this is done?
Answer Hello John. Make sure the motor 131276200 is at the correct angle and you start all 4 supports at the same time. These can be tricky to install, and may need to use a little force to install the motor. Just be careful and don't break the supports. Hope this helps. Read More... Answered by AppliancePartsPros.com | Friday, October 28, 2011