Doug for Model Number Frigidaire Elec Dryer GLER341AS2 Took the front panel off to access the thermostat by the blower,in the process you have to disconnect the door switch. There are three wires going to the switch,but upon trying to remove the switch from the inside, the top plastic part of the switch came off & the wires all fell out & need help in trying to figure how they are put back inside the the switch case.The wires have connector type ends on them & can't figure how they go back in to make the switch work. Any help would be appreciated. The dryer top & control panel started getting extremely hot to touch & took apart dryer to check all the thermostats. Clothes were also taking way too long to dry. I found the shield behind the drum to be almost stopped up with gunk & the area below the lint trap also had alot of lint. Got everything cleaned out,but getting the door switch back together is holding putting everything back together to try. Thanks
Answer Doug, If the door switch fell apart we would not have information as to how it goes back together. The wiring part of the door switch is as follows: on the switch there is a NC, C, and NO. The Brown wire will go to NC, the Blue wire will go to C or Com, and the Gray wire will go to NO. Read More... Answered by AppliancePartsPros.com | Tuesday, April 16, 2013