Customer Questions and Answers for Sealed Gas Burner Head by Whirlpool

Hello Jodi! The burner grates used on your Maytag Range model MGR5751ADW is part number WP7518P464-60. The grates come one per package. The burners come only as a fully assembled part. You will need one WP3412D021-09 and three WP3412D024-09. Here is the information located from the manufacture regarding the removal and installation of the burners. Hope this helps! Sealed Burner 1. Turn off electrical power and gas to the range. 2. Disconnect gas and power from unit. 3. Remove grates. 4. Obtain Burner Wrench (removal and installation tool, P/N AP3854752, see picture below). 5. Place Burner Wrench on burner properly (the wrench is labeled for proper ignitor alignment). 6. Once the wrench is properly aligned on the burner, apply steady and even pressure while turning the wrench counterclockwise. Turn the burner no more than two inches to loosen. NOTE: Some minor crunching or grinding sounds may be heard. This is normal, but be careful not to chip the finish in visible areas. 7. Once loose, lift the burner straight up and out of the mounting hole. 8. Label and disconnect wire terminals from burner. 9. Remove screw and washer (securing burner support to main top) from the burner openings. 10. Replace and reassemble in reverse order.