Tate for Model Number DU902PFGB2 I've replaced the touch pad on the front and the control board inside of the dishwasher. The dishwasher keeps tripping the thermal fuse during the wash cycle. I've replaced several times and it keeps tripping leaving water in the bottom of the washer. When I've replaced it in the past it starts up again in the draining cycle. Any ideas?
Answer Tate, Normally when the thermal fuse is blowing it is due to a higher than normal amp draw on the motor. Check the pump to make sure that there is nothing in the pump that would cause it to jam up. If this checks ok then the motor would most likely be the cause. Read More... Answered by AppliancePartsPros.com | Tuesday, December 30, 2014