Russ for Model Number DU1101XTPB7 I purchased the motor/pump assembly for this model and successfully replaced the defective one. After starting the dish washer up and checking for leaks, I noticed everything seemed to be in check. Operation was much more quiet (as it should be), and after opening the door during the first few minutes of the cycle, I was able to verify that water was recirculating properly. However, after 10 min. of operation the pump more or less stopped working and would just make this droning noise. I repeatedly restarted the wash cycle and keeps doing the same thing: running fine for several minutes, then not recirculating water at all while sounding like the pump or something is running. I don't know if this is a programming issue or what. Please advise. Thanks
Answer Hello Russ. You will need to remove the drain pump WPW10348269 and check for something clogging it. If it is clear, and the pump does not run, you will need to replace the drain pump assembly. Hope this helps. Read More... Answered by AppliancePartsPros.com | Monday, October 17, 2011