How to Troubleshoot & Replace Frigidaire AP4040893 / 318228310 Indicator Light Lens

Turned the circuit breaker off and pulled the stove out. I removed the upper back panel put the lens in place then slid the light over the lens to lock it in place and assembled the back panel. Turned the breaker on and everything works good as new. 

Replaced several red light lenses which had somehow been broken. 

We ordered the parts and my husband and I did the repair. 

I was so impressed with your site! I ordered the parts I needed and you had videos to show exactly how to fix it. The parts went on in 15 minutes but the dirt in the door took longer. The door had to be disassembled and cleaned but it went so smoothly because of your instructional videos on replacing the glass in the door (didn't need new glass but used that video to see how to clean it). I would have figured it out but you sure made it easier and took alot less time than it could have. The parts were excellent and worked perfectly. I didn't have any problems to warn anyone about or any issues at all with the parts I ordered. It was a great experience - I will always recommend this company for anyone with the need for repair or parts. 

Replace indicator light. I thought it would include the red lens (old one melted, not usable), but it did not, so ordered that separately. Took an extra week, but all good now. 

Easy and quick 

I ordered an oven control board from appliance parts pros, that shipped the same day. I installed the new control board, and the oven works great! 

Order 2 new ones and took off the back and replaced very easy to do. 

Replaced switch. The problem I had was while looking at switch the indicator light lens popped. I got on live chat to ask if I had to buy indicator light or could I buy just the lense since I could not find just the lens on their web page. Lady got in touch with their service rep and got back to me with part number for just the lense. Happy ending. I would use these guys again with no problem. 

Replaced the control board, control board overlay and the indicator lens using a phillips screw driver, 1/4" nut driver and a pair of needle nose pliers. Took all of 15 minutes.