How to Troubleshoot & Replace Whirlpool AP6013857 / WP9743590 Door Gasket

Replaced door gasket. It was super easy. Just make sure when taking out the old one you note the orientation of it so you get the correct side of the edge right. Also be sure and start at the top in the middle and make sure you have the gasket divided equally so you end up with the same amount of "extra" on the bottom. 

I ordered new seals from AppliancePartsPros.com. Finding the right seals was very easy, all based on model number of the appliance. While looking my unit over for other signs of wear, I noticed that a repair done by the prior homeowner to the lower wash arm was done improperly: a seal there was set protruding from the cover, the cover was missing screws, and the arm was missing the upper bushing. So I ordered a new seal, the missing screws, and both the top and bottom bushings (just to be safe). Parts arrived THE NEXT DAY. Superb! Repaired everything in about 15 minutes. Everything fit perfectly. No more leak. 

Replaced the tub gasket and the door gasket. The kit included a couple of hinge plastic pieces, I checked out the how to video you guys have. I hand to unhook the door springs and slid the door out as in the video, worked like a charm 

Removed door, replaced the door gasket and the lower seal. 

Replaced door Gasket and Lower Door seal. It was a challenge to get the door off. Also trying to replace those little cups on both sides of the dishwasher was a real challenge. Had a heck of a time removing just one and replacing. I opted to put the original back because they where fine. The dishwasher is still leaking near the lower right hand side. Not much leaking like before, so I'm not quite sure what is going on. 

Pulled off old door gasket . put on new one 

Repair was super-easy; took about 10 minutes. No tools needed. Just pull out the old one and put the new one in the slot. I pulled out the old gasket halfway and started the new gasket to make sure I had everything straight. I ran a load of dishes and there were no leaks. The door now is difficult to latch because of the new gasket. I will give it a few days for the gasket to seat completely before I start to mess around with the latch. 

Replaced the old gasket for the new one. It was the right part and the job was done in 10 minutes perfectly. Already checked for leaks (run the dishwasher) and no leaks. ApplianceParts Pro make the whole process very easy and prices are the best. Very happy. Ali Dadgar