Open oven door. Remove 1 small screw on the flange of each side of the oven. These 2 screws hold the oven to the cabinet. Pull the oven out of the cabinet a few inches. Remove the 2 screws on each side of the touch pad control panel. Pull off the control panel. It will be attached by several wires. Leave these alone, and simply place the control panel on top of the open while you work. Remove the thermal fuse by pulling off the wire on each side, and squeezing the underside of the mounting clips while pushing up. Reverse the above steps with the new thermal fuse. (Note: I removed the metal trim piece below the control panel before removing the control panel, but I am unsure if this is necessary.)