Do-It-Yourself Story

Had to order inner door panel and gasket as they are not separate pieces. Unplug power cord as there are electrical components inside door. With door closed remove the two screws on the bottom corners of the door. Open the door placing something on the floor for the outer door panel to rest on, remove the ten screws that hold the door panels together (note) 6 short screws 3 on each panel side and 4 long ones across the top of the door. Let the outer panel lay on the floor hold the inner panel and disconnect the two wires to the soap dispenser note location of wires. Now remove the 4 screws from the hinges two on each side be careful they are spring loaded and can be unwieldy remove the inner door panel from the unit. Remove 6 screws and two retainers from the soap dispenser remove the soap dispenser from the panel clean as needed, reinstall on the new panel using the retainers and 6 screws ( do not overtighten screws). Next remove the two screws from the vent piece on the old inner panel and remove the vent be sure gasket on vent is in good condition reinstall on new inner panel. Put new inner panel back on hinges and attach with correct screws, reattach the soap dispenser wires correctly, then reattach inner and outer door panels note screw locations 4 long across top of door, 6 short on sides of door, do not overtighten and check fitment as you screw the panels together. Close door install the two screws at the bottom corners of the door, make sure door closes and latches properly, plug unit back into power.