Robert R Mcdade , TX July 25, 2025 Very little cold water going into washer Replaced water inlet valve. Reviewed a few videos first, including one on the AppliancePro site. First, verified water flow at the hose, which was good. Used putty knife to remove control panel after removing hoses from rear of the washer. Just 2 Torx screws to remove part. Unplug connector from control board, insert new part and screw back down. Plug in connector, put hoses back on, reattach control panel. Pretty easy. Do-It-Yourself Rating: Repair Time Estimate: Less than 15 minutes