Do-It-Yourself Story

Pulled oven/range away from wall. Unplugged appliance. Removed oven racks and then the four screws holding fan/heating element cover. Holding fan blade used socket to remove retaining nut and then slid fan blade off of motor shaft. Note: the retaining nut is removed by turning clockwise. Removed screws holding back panel in place exposing fan motor. Removed three screws holding motor in place then disconnected two wires going to terminals on motor. Installed new motor using the same wires and screws. Replaced back panel. After placing fan blade back on motor shaft secured with retaining nut. Restored power to appliance and tested installation of new motor. After verifying proper operation reinstalled cover and oven racks followed by leveling range in original position.