The kit had more parts then needed, but instructions clearly show you which ones are (and are NOT) needed. This problem has existed since day ONE, and it is clearly a manufacturing error because in this kit, it tells you to use different tension latches then what are originally installed ... and the fit is much tighter now then when it was new. The kit provides NO instructions so you have to figure it out. Because the latches that mount in the door are held by clips on all 4 sides (2 are metal - top and bottom - and 2 are plastic - right and left sides), the only way to get the old ones out is to take the 'inner' door OFF, and clip off the metal portions of the latch using diagonal cutters. Then you can use a flat blade screw driver to push in on the plastic latches. The portion of the latch kit that installs into the actual dryer was not used ... mainly because I could not figure out how to get to them ... and secondly because the door is plenty tight now.