I used a multimeter to check continuity on my Heating Element, Ho-Limit Thermostat and Dryer Thermal Fuse. The Dryer Thermal Fuse was the only one with no continuity, but decided to replace all parts. I removed the two bottom bolts to get access to the heating element. Room may be limited, and therefore decided to remove the front panels (careful when removing front panels as they are attached with wires, take note of order). Heating element is located in the Left-Rear side of dryer and is held by two bolts. Remove bolts, heating element should slide down. Once removed, transfer over old parts to new assembly or if new, assemble and place back in the reverse order.