I had to take the lower pannel off and then the pannel around the door. the top was next to come off
the belt was still connected. So I dissconnected the belt took off the front drum support pannel theand removed the drum. The belt was chewed up and the tensioner pully was also very tight. I took the motor out of the machine and found the drive pully on the motor was stripped out on the motor shaft. the motor shaft threads were ok but you cann't get the pully seperate you have to get the hole motor. so I had nothing to loose, I epoxyed the pully back on the motor and thightened it up by hand and let it dry. I replaced the tensioner pully and lubed the shaft. I then reassembled the dryer after vaccuming the inside of the case and also the vent pipe.I ran the dryer unloaded and it worked fine then with a load and it ran perfectly and still is.