Ordered a new Water Inlet Valve. I first watched the video on this site, which is very helpful. I actually was able to change the valve using a few less steps than the video instructions.
Shut the power off, shut the water off, remove the screws holding the dishwasher in place. Pull the dishwasher out, I did not disconnect the water hose from under the sink, I did not disconnect the white hose from the outside of the dishwasher. Disconnect the water feed on the Water Inlet Hose, I was able to have enough room to pass the old Water Inlet Valve into the machine and disconnect the hose from the Water Inlet Valve. It certainly helps resting the dishwasher on a block of wood ( maybe two blocks of wood if you have room) Then do everything in reverse. Run a short cycle on the dishwasher and recheck for any leaks. Done!
The most difficult part is removing the white hose. Use a flat head screwdriver the break the seal. Next time I will order a new hose because it is easier to just cut it off and replace it with a new hose.