Thru troubleshooting the electrical circuits and homing the heat elements with a fluke digital multimeter, I determined that a relay on the control board wasn't allowing the elements get the proper voltage. The controller clock and buttons would work because they only require 120 volts but when you would try and use the oven or burners, which require 240 volts, the relays on the control board wouldn't close to allow the elements to heat properly. Used the part number on the back of the control board and called at 7pm on Easter Sunday and ordered the part. Recieved the part 2 days later, installed it, and all worked well. Thank you very much.