There was a problem removing the bolt which holds the agitator assembly! Whirlpool in its infinite wisdom chose to use a common carbon bolt in a wet environment! Subsequently the bold head was rusted to the point where a socket would not bite. Initially I melted the agitator assembly to get at the bolt. This was a mistake as it destroyed both the top and the bottom assembly. At that point I manage with a 1/4x10 inch drill bit to drill the head off the bolt, which is the approach I should’ve taken initially, and was able to remove the agitator. From then on it was a piece a cake from the video. The videos are very well done and comprehensive. I wouldn’t hesitate to do this repair again. Thanks