Removed damaged Fascia panel and then discovered that there were two Torx screws that needed to be removed. These hold panel to the dishwasher door. Had to remove start button (Part 109), wash setting buttons (Part 107) and the silver door handle (Part 108) from the damaged panel and put them on the new panel. The buttons were easy to remove and install on the new panel. The door handle was a little trickier. Once the center tab was pushed out the handle came out. Getting the panel to properly fit into all the slots was tricky as well. Had to completely remove the door panel in order to slide the door up into the bottom of the fascia panel. This was not apparent at the time and it took a few minutes to figure this out. After this was done, the job was much easier. Saved over $180 doing this job myself!!