The correct parts (WR02X11284 & WR02X10568) are no longer available so I substituted these parts after the following modifications.
The screw hole in Hinge Cam Riser WR02X10140 was enlarged to 3/8” with a Dremel tool, using the original as a pattern.
The outside diameter of Cam and Thimble WR02X11284 is 0.040” larger than the original part and would not fit in the hole of the door. I reduced the diameter with a lathe. I’m sure the OD could also have been reduced with a file though it would have taken more time and the lathe does a nicer job.
The door closes like new now.