Replaced the igniter with OEM igniter. The last igniter I installed was an aftermarket one that cost about $30, and it lasted less than 6 months. Hopefully the OEM one is better. Here's a tip to avoid tearing out insulation when removing/installing igniters: Cut the connector off the old igniter before removing it. Be sure to cut the right wires!! Before installing the new one, tightly wrap foil around the connector to form a bullet like point ahead of the connector. Gently wiggle as you push the connector through the insulation. Actual replacement time is only about 15 to 30 minutes, but I take extra time to clean around and under the range.