Started by taking the drip tray off. Then unscrewed the three screws. Pushed the control panel up. Pressed the wire harness off. Unscrewed the next 3 screws. Pulled the water line out. Unddid the wires again. Pulled the ice/water mechanism out. Pushed the torsion spring out. Put the new part in place. That was the tricky part. It has to be put in flipped up, replace the torsion spring, and then pushed down into place. Reconnected the wires. Pushed the water line back in place. Put the ice/water mechanism back in place. Replace the three screws. Reconnect the wires. Pushed the control panel on then down. Replaced the three screws. Replaced the drip tray.