Ordered and installed a new control panel. Remove four T-15 Torx screws on each side on the inside of the washer door (total of 8). Remove two screws on the inside of the washer door at the top to release the door latch. The front and inside of washer door will then separate. After slightly separating the door look from the outside of the washer door to the inside. There is an additional screw to remove so the control panel will become free. There are a couple of plastic tabs to push to finally free the control panel. Unplug the cable from the control panel. Plug in the new control panel cable, then reassemble new control panel to the door.