Maytag Legacy Series Dryer Model# SDE515DAYW (Designed by Amana)
Replaced the following:
Dryer Glides and glide felt pads
Drum Support Rollers
Belt Tension Pulley
Belt
We still had the noise so the next logical thing to replace was the motor as the sealed bearings can be an issue.
Replaced the Motor and Blower Wheel.
The dryer blower wheel was permanently attached to the motor shaft and I had to use a Dremel tool to cut the blower wheel off of the shaft. No big deal with the Dremel tool but another 2 day wait for a part.
I removed a ton of lint in the blower ductwork just below the link trap that had reduced the air flow by at least 50%. The performance of the dryer is much better now as it no longer gets too hot. I highly recommend periodically removing the access panels to clean the ductwork between the lint trap and the blower. Maybe every couple of years.
Also I could not find a clear direction on whether to lubricate the shafts where the rollers and tensioner pulley wheel are installed. I cleaned something off of the old shafts which lead me to believe that some lubricant had been used previously. I chose to use Permatex Ultra Disc Brake high temperature grease. Seems to work great. Some say it will attract lint and be an issue. We will see.
The videos do not show my particular model but are similar enough for me to be able to disassemble and reassemble with no issues. My skill level is I can usually do a job like this but it takes about 5 times longer than a Pro due to the learning curve.
AppliancePartsPro is so easy to use with incredibly fast shipping. You won't be disappointed.