I purchased part # AP6014070 (WP9760774) for my Kitchen Aid KEMS378SSS00 Oven/Microwave. First turn off the breaker to your oven. After removing the oven racks and door I removed 2 screws holding the oven temperature sensor and pull it down slightly so it would not be in the way of removing the upper coil. I removed the 4 screws holding the upper coil and very gently pulled the coil out from the back oven wall exposing the wires and connectors. Before disconnecting the spade connectors from the coil, I attached an alligator clip to the rear of each spade connector to prevent the wire from being pulled back into the rear of the oven where it would be out of reach. The previous step is extremely important otherwise you might have to remove the entire oven to access the wires from the back of the oven. Gently remove each spade connector from the coil and then attach the new coil. Make sure each spade connected is securely attached so it doesn't come off when reinserting the new coil back into the oven. Fasten the coil to the oven top and lastly fasten the oven sensor. Install the racks and oven door, turn the breaker back on and turn your oven on to verify everything is working as it should.