Do-It-Yourself Story

Had a little trouble getting the correct part number, but with the help of Appliance Parts Pros very knowledgeable customer service. The correct part was ordered. Removed two screws to access inside panel of door. These screws also secure the door handle. Removed an additional 4 screws to completely remove the old handle. Assembled the new door handle consisting of three pieces. Attached the door handle to the outside of the door with the four screws. My oven door had alignment holes for the alignment pegs that are located on the door handle assembly. Then close the inner panel and fasten with the two remaining screws. The handle has locating pegs on it, so when the panel is closed the two remaining screw holes on the panel should align with the additional holes on the handle that accept the two remaining screws.