I took the oven racks out, then removed the two screws that held the lower panel of the oven panel on, then removed the panel. I then removed the 4 machine screws that held in the lower inner panel of the oven, then removed that panel. I removed the machine screws that held the oven igniter in place, pulled it out, and followed the wires to their connection (the connector for these wires is located behind the storage drawer at the bottom of the range). I then disconnected the wires and pulled the old igniter out of the oven. Installation of the new igniter was the reverse of the removal. Some caution was needed in installing the new igniter as the carbon element is exposed and is fragile.