I ordered the rotary start switch and 2 new knobs. The front panel came off easily after removing the 4 screws on top (had a find a unusual screw tip to fit the hole though), and carefully removed the two wire clips from the old switch and put it on the new switch. To get the old one off, you had to turn it clockwise 1/8 of a turn and pull it off. Notice how the little prong on the bottom fits into the slot--this was the only part that we were a little unsure about when attaching the new one. When we had that little prong in correctly, then turned it counter-clockwise, it snapped into place. We put the panel back on--and it worked! Yeah