Followed your replacement directions on all items. The infinite burner switch was fixed exactly as your web site indicated. Also used your instructions on the bottom trim channel of the oven door. Unfortunately, we had delayed replacing it and it was corroded which made the replacement longer and more complicated. Had to gently use a single blade scraper blade to dislodge the rust between the old trim channel and the glass and gently work the channel loose. However, with persistence and patience we were able to gently scrape out the rust that was on the channel which was binding tight to the door glass without damaging the glass. I should have replaced it much sooner and the job would have gone much faster. Other than that, everything went well. I would not recommend others to use a single edge blade unless they were extremely careful since it could result in getting cut. My advice would rather be not to put off replacing the part since it gets more difficult as time passes and more rust builds up in the channel that holds the outer glass in place.