Tipped the washer back (45 degrees) and removed the belt connecting the motor, drum and water pump assembly. Then I removed 4 screws from access panel on rear of washing machine (where drain hose enters the machine). Once the panel was off I had easy access to the drain pump assembly (it's right behind the panel that was removed). Removal of the drain pump assembly was a snap.. just needed use channel lock pliers to release the clamps which allowed me to remove the water lines to and from the pump. Then I removed the 3 easy to access screws that attached the water pump assembly to the bottom of the machine. Reversed the steps to install the new pump. Total repair time was under 15 minutes start to finish!