I order the inlet valve which I'm not sure I needed. I say that because the fitting going to it was galvanced & it rusted shut. The actual hose had big chunks of rust in it which I had to dig out with a welding rod.The new valve had the elictrical connectios in a different place so I just compared& plugged it in going by that.One tip for all out there make sure door is closed when turning on. I didn't & I though that I accomplition nothing. I was wrong. I haven't put the covers back on because I figure I'm going to replace the hose which I'm going to say needs replacing. If it wasn't so tight space & I didn't have the rust problem along with me not being in better shape. It would have took me 15 minutes to change. It was about a hour. It gets the dishes clean now. I can hear & see the water in dish washer now.