General Electric Control Board

Fix an oven that won't maintain accurate temperature or runs too hot. This electronic control board regulates heating cycles. Moderate difficulty repair.

Left-side generator module circuit board for cooktop ignition control. Replaces damaged, non-functioning, or corroded modules. Installs on left burner.

Fix a washer that won't advance cycles or stops mid-cycle with a timer control replacement. Restores automatic cycle progression and proper timing.

If your freezer controls aren't working or the display is blank, this transformer supplies power to freezer control circuits. Restores normal function.

Generator module circuit board for cooktop control systems. Replaces cracked, damaged, or malfunctioning boards. Installs in control housing unit.

Dryer won't start or advance through cycles? This timer control regulates cycle timing and functions. Moderate DIY repair with basic tools.

Replace a faulty dryer timer when cycles won't advance, stop mid-cycle, or the timer knob doesn't turn. Restores proper cycle operation and timing.

Fix a microwave with a blinking display, flickering screen, or completely dead unit. This power control board restores normal operation. Moderate DIY.

Fix a washer that won't advance through cycles or skips fill/agitate steps. This timer controls cycle sequencing. DIY repair in about 30 minutes.

This genuine replacement part is a user interface board for dryers. The user interface board is the circuit board that responds to the buttons located on the control panel allowing the user to adjust the dryer settings. If the dryer is no longer responding when buttons are being pressed then it might be time to replace the user interface board. Luckily this is a relatively easy repair.To replace the interface board begin by turning off the power to the dryer. Once the power has been shut off move the dryer away from the wall to gain access to the upper back panel. Remove the panel and locate the interface board. Snap it out of its brackets and remove the wire harness attached to the board. Reinsert the wire connector to the new interface and snap the new board assembly back to its original place.This OEM replacement part is sold individually and is compatible with General Electric, Hotpoint, and RCA brand Dryers.

This is an electromechanical timer that controls the duration and sequence of the dryer's operating cycles. It advances through each stage of the drying cycle and signals the motor, heater, and other components when to turn on and off. Replace this timer if your dryer won't start, won't advance through cycles, runs continuously without shutting off, or if the timer knob turns but nothing happens.

Fix a dryer that won't shut off or has a dial that doesn't advance. This timer controls cycle length and automatic shutoff. DIY-friendly, 10-20 min.

Oven won't maintain temperature or heats inconsistently? This relay board switches power to heating elements as directed by the main control board.