General Electric Control Board

Fix an oven that won't heat, has a blank display, or shows error codes with this control board clock. Restores timer and temperature functions.

Lower oven not heating? This relay board switches power to heating elements for bake and broil functions. Restores reliable lower oven operation.

If your range display is blank, buttons aren't responding, or oven won't heat, the control board may have failed. Moderately difficult repair.

Fix an oven that won't maintain accurate temperature or runs too hot. This electronic control board regulates heating cycles. Moderate difficulty repair.

This right-side generator board is the replacement control board that completes the unit's ignition/control circuit, restoring proper operation and reliable starts. Use it to replace a damaged or non-responsive right-side generator board. What it does:

• Routes ignition/control signals to the right-side components and helps enable proper spark or control functions
• Common symptom: no ignition or intermittent starting on the right side
• Common symptom: erratic or no response from the affected side's controls
• Helps restore normal operation when the original board is cracked, burnt, or electrically damaged

• Disconnect power (and gas, if applicable) before starting any repair
• Handle the board by the edges and avoid static discharge; use ESD precautions if available
• Inspect connectors and wiring for heat or corrosion; replace damaged wiring or connectors

Generator control board for cooktop center module. Replaces cracked, damaged, or malfunctioning circuit board. Mounts inside cooktop control assembly.

Fix a stuck or misaligned oven drawer with this slider assembly base. Restores smooth gliding action when drawers won't open or close properly.

Fix a washer that won't advance cycles or stops mid-cycle with a timer control replacement. Restores automatic cycle progression and proper timing.

Dryer won't start or advance through cycles? This timer control regulates cycle timing and functions. Moderate DIY repair with basic tools.

Replace a faulty dryer timer when cycles won't advance, stop mid-cycle, or the timer knob doesn't turn. Restores proper cycle operation and timing.

This electronic control board manages your refrigerator's key systems—compressor, fans, and defrost. When the original board fails, you may see warm temperatures or erratic behavior; replacing it restores stable cooling and proper defrosting.

• Regulates compressor and fan operation to maintain set temperatures
• Controls adaptive defrost timing and energizes the defrost heater
• Distributes power to critical loads and processes sensor inputs
• Helps with: no cooling or intermittent cooling, compressor/fans not running, heavy frost from no defrost, or unresponsive/erratic controls

• Disconnect power before servicing; risk of electric shock
• Use ESD protection; handle the board by the edges only
• Photograph and label connectors; transfer wires exactly and fully seat each plug
• After installation, restore power and follow any model-specific service sheet/configuration steps provided with the appliance

Dryer won't advance cycles or shuts off at wrong times? A faulty timer is usually the cause. This control restores proper cycle timing and progression.

Fix a washer that won't advance through cycles or gets stuck between wash and spin. This timer controls cycle sequence. DIY repair in 10 minutes.

Fixes washers that won't start, agitate, or spin. This control board manages cycles and user interface. DIY repair typically takes under 1 hour.