General Electric Control Board

Dryer won't shut off or timer won't advance? This mechanical timer controls cycle timing and program selections. Restores proper cycle operation.

Washer won't start or stops mid-cycle? Flashing lights or unresponsive controls? This control board assembly restores function. 10-minute DIY repair.

Washer won't advance through cycles or timer dial doesn't respond? This mechanical timer restores timed operation and reliable cycle progression.

Fix a refrigerator that won't cool properly or has unresponsive temperature controls. This control board restores temperature regulation in about 1 hour.

Fix unresponsive buttons, flickering lights, or intermittent fan operation. This control board restores full function to your range hood. Moderate DIY.

Microwave not working or no power? The relay board controls power distribution to the magnetron and fan. Requires control panel removal to install.

Fix a washer that won't start, has no display, or won't respond to buttons with this control board assembly. Houses cycle selector and display panel.

Fix a range clock that won't display time or control oven functions with this timer control board. Complex repair—professional installation recommended.

Oven won't reach temperature or displays error codes? This electronic control board manages oven timing, temperature control, and self-clean functions.

Fix an oven that locks up or won't respond to controls with this control board. Monitors and regulates temperature settings for reliable operation.

This relay board assembly controls and routes power to key appliance components, restoring reliable switching for motors, compressors, or heating elements. Replacing a failed relay board can resolve intermittent operation and restore normal function. What it does:

• Switches power to major loads so motors, compressors, or heaters run when commanded
• Replaces worn or failed relays that cause intermittent starts or clicking noises
• Helps stop erratic operation or loss of function in affected circuits
• Prevents overloads from passing through a damaged relay assembly (when replaced)

• One relay board assembly

• Disconnect power to the appliance before starting any repair to avoid shock or damage
• Handle the board carefully; avoid touching contacts and use ESD precautions if available
• Verify connector orientation and seat all wiring harnesses fully during reassembly

The Encoder Assembly is an OEM part for GE gas ranges. It digitally converts analog knob movements into signals to control the gas valve, igniter, and temperature settings. 

Causes of a bad encoder assembly include degradation of internal sensors and switches over time, loose wiring connections, or impacts that cause misalignment.

Symptoms of a bad encoder assembly are:

• Delays or errors when trying to light burners
• Inaccurate flame height and temperature level responses 
• Knobs feel sticky, sluggish or jump between settings
• Error codes indicating control module communication issues

This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore gas range models.

Fix error codes, blank displays, or unresponsive controls with this oven electronic control board. Restores timed cooking and temperature management.

Fix a washer that won't advance through cycles or stops mid-cycle with this timer control. Restores proper wash, rinse, and spin sequencing.

Range not heating or igniting? This control relay board routes power to igniters and burners. Fixes intermittent operation and failed starts on gas ranges.

Oven won't heat or turn on? This electronic control board restores timed baking, broiling, and temperature regulation. Moderate DIY repair in 1-2 hours.