Heating Element

• Little to no heat when baking

The delivery of the element was superfast, less than 24 hrs. Unplug the Stove from the receptical! Took a phippips screwdriver and took out the 2 screws holding it, and tilted it upwards a bit and pulled the element out about 3 inches an unhooked the wires. Hooked the wires up to the new element and pushed it back into the holes and put the 2 screws back in and turned the stove on and that was all there was to that. Read more

Find the part at Appliance Parts Pros; watch the youtube video on how to replace it and voila! Done in a flash. Thanks Read more

• Little to no heat when broiling
• Element will not heat

Replaced element Read more

I took the model number of the oven and typed that in followed by replacement backing element.there was a photo of the element that matched the original. They provided an online tutorial as to how to install it. It was very easy because the electrical contacts at the ends of the new baking element slid right into the electrical contacts inside the oven cavity. The only thing that you had to be careful about was loosing the electrical contacts deep inside the oven. But I didn't see it as much of... Read more

Ordered the burner and it arrived and I simply plugged into the receptical and mission accomplished Read more

Replaced with element purchase from appliancepartspros.com. . Read more

Appliance Parts Pro' 1" gridded photos of elements helped insure I got the right bake and broil elements for my stove. Super fast shipping was promised in two days and came in one day. The tough part of the repair was getting the rusted sheet metal screws off to remove the old elements. The tough part of the purchase was that no one had an index of parts by the old GE model numbers. For the first time in years both ovens of our GE 1971 40" double stove work. Read more

My 1984 GE Electric Stove model number was very close to an another entry, but not actually in appliance repair pros' model numbers list. But my burners looked and measured the same for the near entry number, and the surface unit control switch looked very similar. I decided to take a chance and ordered 2 of each.. (Actually I wouldn't have needed new burners but an earlier "repair guy" took 2 of my burners and never returned - and no one could find him!) It turned out the new burners fit... Read more

With a screwdriver and some mechanical aptitude. Nothing harder that a few screws to change the parts. Read more

• Oven not heating evenly
• temperature not accurate

Removed 4 screws from back panel and removed back panel. Removed 3 screws and 3 wires from heater element and removed element. Reversed procedure with new element and seal. You will need the seal! Old one crumbled apart. All took less than 10 minutes. Read more

Bought new electric terminal block kit wiring component and new surface element burner installation was very easy after we watched demonstration on how to do the wiring..works like a new stove and really was super easy do it......we figured by doing it ourselves we saved around $200.00 in service call. installation and marked up parts....we received the parts we ordered super fast Read more

Replaced element. Replaced the connector on wire and installed new element Read more