Kenmore Air Conditioner 253.8771063 (2538771063, 253 8771063) Parts

Replacement mounting screw for securing switches in air conditioners and related appliances. Needed when original screw is stripped, missing, or lost.

Structural mounting bracket for air conditioner units. Replaces cracked, broken, or damaged brackets that secure components. Direct fit replacement part.

Structural frame component for air conditioner units. Replace if cracked, bent, or damaged to restore proper housing support and secure installation.

This tube connector joins the refrigerator water line to internal tubing, restoring a secure, leak-resistant connection for the ice maker and dispenser. Use when a cracked or loose tube causes leaks or poor water flow. What it does:

• Connects and secures the refrigerator's water tubing to internal fittings.
• Prevents leaks and helps maintain proper water flow to the ice maker and dispenser.
• Commonly replaced for visible cracks, splits, or loose fittings that cause dripping.
• Works with rigid or flexible water tubing depending on the appliance plumbing layout.

• Turn off water supply and unplug the appliance before starting work.
• Verify tubing sizes and seating; push tubing fully into the connector until it locks (or secure per OEM fitting style).
• Inspect nearby tubing and fittings; replace any damaged sections to prevent repeat leaks.

A round-head wood screw used to secure trim, panels, and small interior components on compatible appliances. Simple replacement that restores proper fastening where the original screw is missing or damaged. What it does:

• Replaces a stripped, missing, or rusted wood screw to restore secure fastening of panels, trim, and mounts.
• Provides a rounded head finish that sits above or countersinks in thin trim pieces.
• Matches the OEM length and thread style for reliable fit in prepared wood or composite mounting points.
• Helps stop rattles, loose panels, and misaligned trim caused by worn or missing fasteners.

• One wood round-head screw (8-15A x 0.750)

• Use the correct-size screwdriver or driver bit to avoid cam-out and head damage.
• Start threading by hand to avoid cross-threading; drive until snug—do not over-tighten.
• If replacing a rusted screw, check surrounding material for damage and replace any compromised anchors.
• Disconnect power to the appliance and follow manufacturer service instructions before servicing.