Kenmore Air Conditioner 580.73089300 (58073089300, 580 73089300) Parts

Replacement drain pipe that routes wastewater from the appliance pump to the home drain. Restores proper drainage and helps prevent leaks or standing water when the original tubing is cracked, clogged, or damaged. What it does

• Directs wastewater from the pump to the household drain so the appliance can complete normal drain cycles.
• Replaces cracked, split, kinked, clogged, or leaking tubing that can cause slow draining or standing water.
• Fits the OEM drain outlet and drain connection; secures in place with hose clamps to maintain a watertight seal.
• Matches OEM shape and routing to avoid pinches or improper drainage.

• Always unplug the appliance and turn off the water supply before beginning service.
• Remove the access panel to reach the pump/drain connections; detach the old pipe and install the replacement in the same orientation.
• Use the original hose clamps or replace with equivalent clamps; tighten until snug—avoid overtightening.
• After installation, run a short drain cycle and check all connections for leaks.

This NTC thermistor assembly senses temperature and sends readings to the control board so the appliance maintains the correct cooling cycle. It replaces a failed or intermittent temperature sensor to restore proper temperature regulation. What it does:

• Measures compartment temperature and relays the signal to the control board
• Helps the appliance decide when to run compressor and fans for stable cooling
• Commonly replaces units that cause incorrect temperature readouts, excessive frost, or compressor cycling
• Works as the OEM temperature-sensing element in the appliance's refrigeration system

• Disconnect power before accessing internal components to avoid shock
• Handle sensor and wiring gently; avoid bending or crimping the thermistor tip
• Verify connector seating and routing to prevent pinched wires or interference with moving parts

Note: Contains Left and Right curtains, foam seal and hardware.

This main power control board manages a major appliance's electronic functions and power distribution so the unit responds properly to user inputs and cycles. Replacing a faulty board restores control and helps appliances run reliably. What it does:

• Regulates power to motors, valves, displays, and sensors via the appliance's main control circuits
• Processes user commands and signals from sensors to start, stop, or change cycles
• Commonly replaces boards that cause unresponsive controls, intermittent operation, or failure to power on
• Helps stop unpredictable behavior like random cycle changes, error codes tied to control faults, or no display/power

• One main power control board (PCB) only, as shown

• For safety, disconnect power before testing or replacing the board and follow manufacturer service instructions
• Static-sensitive component: handle by the edges and avoid touching circuitry
• Some repairs may require accessing internal panels and removing connectors; keep track of mounting hardware and wire locations
• Inspect related parts before powering up the appliance