Ej Zoor January 28, 2021 for Model Number GLGC36S9ESA The big burner (lower right burner) does not come on with ir existing igniter, I can see the spark, but no flame , so I have to use the lighter. I have cleaned & cleaned but no change Any idea why. Other 4 burners work fine
1 Answer Ej zoor, Based on the information provided if you see the spark at that burner and it doesn't lite then something is stopping the gas from getting to the spark, especially if it lites with a match/lighter. Read More...
Anne November 19, 2017 for Model Number FGF366ECB I need a surface burner head, but for the Power plus burner. Are there different sizes?
Katy H January 06, 2017 Hi I have a 15-year old Russell Range and it needs gas tubing, igniter and one burner replaced. I don't see a model # anywhere on the unit and have lost the paperwork over the years.....any help?! Thanks
1 Answer Katy, Unfortunately we do not carry any parts for Russell Ranges to be able to assist. Read More...
Joe October 12, 2016 I have a Frigidaire Stove Model FGF366ESC and the big burner will not ignite without a match and I can see the spark and smell the gas .
1 Answer Hello Joe. It sounds like the burner is dirty. You will need to take the burner apart and clean it really well. Also, make sure it is dry before using it. Read More...
Sue April 10, 2016 for Model Number PLGF389CCC One side of the large front burner burns very low. If I get a new AP3584154, will that solve the problem? Thanks.
1 Answer Hello Sue, This is most often caused by a spill into the orifice. It can normally be cleared with a safety pin to clear the orifice, and white vinegar and an old toothbrush to clean the burner. Read More...
Sydney H March 21, 2016 for Model Number peerless M#GFA100WP I am trying to find replacement burners for a peerless premier stove model#gfa100wp
1 Answer Sydney, The part number for the right and left rear burner is 1399 will need 2. The right and left front burner part number is 1398 would need 2 of these. Read More...
Greg November 13, 2015 for Model Number FPGF3685LSA The two large burners on the range top have uneven flame length. On the high setting, the flame length on one side of the burner is much larger than the opposite side. The burners are completely clean and the caps sit level. Any ideas? I sure can't figure it out.
1 Answer Greg, Pull off the burner knob and inside the shaft there will be a set screw to adjust the flame. Read More...
Phil July 22, 2014 for Model Number Frigidaire PLCS389DCB Main gas burner not lighting. can see spark, and light with match only. Exchanged igniter from other burner and working fine want to know what part to replace as they can be costly
1 Answer Hello Phil. If the unit is sparking, but is not lighting, you will need to clean the burner and the burner cap on the unit. If it is dirty, it will not light properly. Read More...