1 Answer Bob, To remove the baffle, there is a screw that you have to remove from the outer part of the inner tub. You can try to do this one of 2 ways, the first would be to remove hoses from the tub and see if you can access the screw to remove it to get the baffle off. The other way to do it is to pull the tub and separate the tub in order to get the screw out. Read More...
Karen October 19, 2012 for Model Number GLTF2940FS1 This baffle kit contains a screw. None of the baffles in my machine have a screw to hold it in place. Just wondering if this is the correct part for my model (looks like the correct part, just without a screw)? Thank you.
1 Answer Hello Karen! Yes, the drum baffle 134509600 is the correct replacement listed for your model GLTF2940FS1. The manufacturer shows the baffle and the screw together in the diagrams. The tabs hold the baffle in place and the screw secures it to the tub. Thanks. Read More...
Steve September 18, 2012 for Model Number atf6700FS1 The page 3 blow up part (#17) AP3844463. The detail phot shows both a screw & baffle. How is it shipped?
Tony November 28, 2011 for Model Number AP3844463 The directions show after unscrewing the exposed screw that comes with the kit to insert a 4" flat screwdriver in the center hole to bend open the tab from the drum and then slide the vien forward to release. It says this can be done without removing the drum. Is this accurate?
1 Answer Hello Tony. Yes, but be careful and don't break the tub. You can then replace the kit 134509600 Read More...
Tony May 02, 2011 for Model Number atf6000fso How does the part number ap3844463 attach to the tub? Do I have to take the tub apart, and screw it from the outside of the tub, or can I slide it into the grooves in the inside of the tub and screw it from the inside?
1 Answer Hello Tony. You will need to take the tub apart to access the screw holding the baffle in place. Hope this helps. Read More...