1 Answer Cobb, Here's some help : "Removing the idler pulley assembly: 1. Disconnect the dryer from electricalsupply and remove the rear access panel. 2. Release the belt from the motor pulley. 3. Release the idler spring from the motor and lift the assembly off the motor." Looking at the idler assembly from the access panel, and with the idler assembly in the up(1 o'clock) position, you'll insert one end of the spring into the small hole to the left and at the end of the idler assembly. The other end of the spring will be inserted into the small hole of the motor mount assembly, on the left side of the plate, then install the belt. Thanks and Good Luck. Read More...