Greg H. June 07, 2016 for Model Number CGS990SET1SS How do you remove the Bottom Oven Assembly? I removed the two screws in the back, but it will not lift out. Do you have to remove the fan cover?
1 Answer Hello Greg, Remove the two screws in the rear and slip your fingers into the vent holes. You will lift the rear of the panel and slide the bottom panel to the rear since it is hooked under the front frame. Once you have slid it back far enough, the entire panel will lift out. For this reason, reinstalling is in the exact reverse order. The panel is slipped into the bake compartment at about a 45° angle, (front down), and slip the front of the panel under the lip in the front of the bake compartment. Once in place, slip it forward so the rear of the panel can be slipped down into position. As a note, if the holes do not line up the panel can be slipped back a bit to line them up. A flashlight is valuable in this instance. Read More...