Edgar Rosado June 12, 2017 for Model Number ZE2160SF02 How do I get my microwave honogram to heat. i change the control board because it would stay stuck and it did it on and off so the control board seem to be fixing the problem when i test it. So I test it a few times but didn't put a glass of water in the microwave and then it started smoking. So after testing all I got a new magnotron and it started to make humming noise so i thought it would now heat but nothing yet also i replace the diode on the capacitor and still sounds like its heating but no heat. should I change capacitor or transformer. Don't no what to do. please help
1 Answer Edgar, This issue would most likely be caused by a faulty capacitor on the unit. Read More...
Mike W January 22, 2015 for Model Number JE2160SF01 Microwave died I replaced the fuse it worked fine until I unplugged it. I put it back together and it was dead. It had blown the fuse when I unplugged it. I replaced the fuse again put it back together and then plugged it in and it works fine until it's unplugged. any ideas?
1 Answer Mike, With the fuse blowing you will want to check the door switches to make sure that they are good and if they check ok then the control board will most likely be the issue. Read More...
Terence February 17, 2014 for Model Number JE2160SF01 GE - MICROWAVE Mod # JE2160SF01. I recently (11/05/13) had the capacitor replaced by an appliance repair company. The 30 day part warranty was 3 days short of expiring when the microwave died again (12/02/13). The same repairman came out, checked it & said it was the fuse. He replaced the fuse & the microwave worked until today (2/17/14). I replaced the fuse, & plugged the microwave into an extension cord (I was outside) & boiled a cup of water. I then refitted the microwave back into the cabinet, after setting the clock, I opened & closed the door & the microwave died again. After resetting the breaker, the same thing happened 3 more times. I have just reset the breaker again, 4th time (a dedicated circuit) & the microwave came back on. I reset the clock, put a cup of water in & pressed the time cook button for 3 minutes. After 3 minutes, the water was boiling? I have read that closing the door could/might be the problem with the door switch .We are not heavy handed when closing the door so I feel it is not abused. Is there a way of checking the door switch to see if it's the problem. Also, is it true that the Magnetron is warrantied for 10 years by GE? The capacitor label has the following numbers on it & I'm not sure what the correct replacement part numbers are if I need to replace the capacitor: CAPACITOR: 21CH115S080Q, 2100VAC 50/60 HZ, 1.10 uF +- 3%B, 10/85/21 CLASS S no PCB, SAMWHA CAPACITOR Co LTD. Thank you for your assistance.
1 Answer Hello Terence. Yes, the door switch is bad and is blowing the fuse. You can test the switch with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...