Customer Questions and Answers for Orifice Spud by Ge

Seth, To convert the unit back to natural gas you will need to get the orifice holders for the top burners left front W11230935, left rear W10643269, right front W11685612, right rear W10643271 and center W10643272. for the bake, you will need upper W10342662, lower W10342661, and the broil W10292293.

Mike, Natural gas orifices as follows: broil WB28K10310 bake is adjustable LF & LR WB28K10023 RF WB28K10032 RR WB28K10031

Deb, unfortunately the manufacturer does not list the LP orifices for your model individually. The manufacturer specifically lists only the LP conversion kit [wb28x29963] in the parts diagram for your model.

Nana, The part number for the LP orifices should be WB28K10376.

Stephen, According to our information, the top burner orifices are all the same WB28K10022 / WB28K10022 RANGE NATURAL GAS ORIFICE. The oven bake and broil orifices are "adjustable" you'll need to turn the orifice hoods up/counterclockwise 2 to 3 revolutions, and adjust the air shutter down/close to 3/4 of the opening. the gas valves do not need to be converted, but you will need to remove the cap from the gas regulator on the stove, remove and "flip" the pressure pin to the natural gas position. Make sure remove power and the gas supply to the range before you start the conversion.

Hello Chris, for the small burner you'll want to use orifice part number WB28K10029, for the medium burners you'll need part number WB28K10022 and for the large burner you'll need part number WB28K10030. You'll want to turn the orifices on the oven 2 1/2 turns counter clock wise and make sure you convert the regulator back to NG. Good luck!

Don, To change back to natural gas you will need the orifice holders left front WPW10273133, left rear WPW10273135, center WPW10319347, right rear WPW10273139, right front WPW10273141.

David, To convert this unit to LP you will tighten the orifices in the over 1 1/2 to 2 turns down and open the air shutters all the way. Flip the cap on the regulator from NAT to LP and replace the 4 orifices on the top with the LP orifices WB28K10023 You will need 4 of the top burner orifices.

Harriet, The model number listed is not coming up as being valid but if the burner is sparking but not lighting you will want to clean the burner cap and burner head as they are going to be the most likely cause for the issue.

John, You will need to replace the top orifices which are are part numbers left front and left rear orifice WB28K10022, Right front orifice WB28K10030, and right rear orifice WB28K10029. You will need the bake and broil orifices part number for bake is WB28K202 and broil WB28K10018. You will also need to close off the air shutters on the burner tubes and flip the cap on the regulator from LP to Nat.