Joanne August 25, 2017 for Model Number WBSE3120B1WW I turn the dial till the lights go on for wash cycle and then press the rubber button and once in awhile the machine will start but not very often. What parts could it be?
Greg April 22, 2017 for Model Number Wbb4500e1ww My washer will not final spin,motor does not come on,and sometimes machine will overfill,have cleaned tube to pressure switch.
1 Answer Greg, This issue sounds likely that it would be caused by a faulty pressure switch. Read More...
Gary W January 22, 2017 for Model Number WBSE2090A0WW Water is trying to fill the Tank, but tank wont fill.
1 Answer Gary, This issue would most likely be a siphoning issue and you would want to check the drain hose to make sure that the hose is not pushed too far down into the stand pipe. If it is the water will just flow in and right back out. Read More...
Randy September 05, 2016 for Model Number WJSE4150B2WW My GE washer will fill, wash and drain but wont spin. I cleaned the tube to the pressure switch. It will spin once in a while but not every time. What part do I need?
1 Answer Randy, You will want to check to see if the motor is engaging when it goes into the spin cycle. If the motor just hums and does not turn on then this would likely be a issue with the timer contacts sticking between agitate and spin. If the motor is turning and the belt is turning then the brake would most likely be bad and transmission would need replace. If the unit was making a loud screeching noise during spin prior to no spin issue then it could be a bad tub bearing. Read More...
Kathy July 15, 2015 for Model Number WJSE4150B1WW (GE) Machine stops at drain cycle - it sometimes drains, sometimes not - I took out the pump, it seemed to be working and it was getting power - but at times it sounds like it is trying to start up and can't seem to do it. If I unplug the machine and wait a bit and plug it up again with the knob between rinse and spin and turn it on it will drain. I did three loads this morning and then it started not draining again and the unplugging did not work this time.
1 Answer Kathy, If the drain is getting power but is not pumping out then this issue will be caused by either something getting caught in the drain pump or a bad drain pump which would need to be replaced. Read More...
Fixnmystuff October 11, 2014 for Model Number wbse3120b2ww The water temp control is out of whack! When I select cold, it comes out hot. I found a spot in the warm section that dispenses cold water. Do I need to change the whole control panel? I was wondering why my energy bill was a bit high this year, and my clothes were feeling tight.
1 Answer Fixnmystuff, You will want to check the resistance of the thermistor on the water valve. The thermistor should have a resistance of 10K ohms at room temperature. If the resistance is not correct then you would need to replace the water valve part number WH13X10010. If the resistance checks ok then you will need to replace the main control board part number WH12X10224. Read More...
David October 18, 2012 for Model Number wjse4150b2ww My washer doesn't stop filling but will run through all the cycles if I manually turn off the water everytime it fills. Which part should I replace? The pressure switch or the water valve?
1 Answer David, if you have to manually turn the water off at the watersource the issue is in the inlet valve assembly, part number WH13X10024. Thanks! Read More...